You can stand it next to the hit, then use both hands to adjust the router.įit an O-ring-buy 'em al an auto-parts store-on the shank of each bit you have. Where the bit opening is not closely matched to the bit diameter, a combination square is the best for setting bit height. For my router work, 32nds is usually sufficient. Machinist's rules often are graduated to 64ths, which is too fine for my bifocaled eyes. Ihis one has the first inch graduated in 32nds. (This isn't a particularly safe operating situation, either.) Using the combination square is your best bet here.Ī good steel rule is ideal for setting bit height. A '/»-inch dovetail bit jutting through a 2-inch opening isn't one your rule can cozy up to. It helps immeasurably to have the bit opening in the mounting plate closely matched to the bit diameter. To set the bit's height accurately, you need to get your line of sight even with the bit. A 6-inch square is ideal to use with the router table, in my estimation. These squares have a variety of graduations on the rule, one of which is certain to suit your purpose. A lot of woodworkers keep a combination square at the router table and use it to set both the bit height and the fence. Of course, the first inch is the most important in setting the bit height.Ī practical measuring device is a 6-inch steel rule, which you can usually buy at an art-and-drafting supplies store. The hook riveted to the tape makes the first inch of the tape virtually unusable for measuring purposes. use a steel ruler rather than a tape measure. This isn't a diflicu It task by any means, but a couple of tricks can make the job easier and the result more accurate.įirst of all. After the bit is firmly chucked in the collet, you need to set the height.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |